Skip to main content Skip to search Skip to main navigation
Free shipping from €150 in Germany · from €200 within the EU (excluding bulky goods) Shipped worldwide every day Over 20,000 parts in stock

Rear wheel hub PCD 4x130 type VW

Product information "Rear wheel hub PCD 4x130 type VW"

Wheel hub for disc brake system BOOM Trikes Classic with VW Beetle rear axle (steel semi-trailing arm or swing axle). Attention: Classic trikes with BOOM aluminium semi-trailing arm axle (muscle) require item 1012064. The castle nut for fastening must be tightened to 350 Nm (three hundred and fifty! not a spelling mistake!), otherwise the wheel hub will be damaged after a very short time.
Make: BOOM Trikes, Wolf Trikes
Position: left, right

General information

Wheel bearings and wheel hubs are safety-relevant components that are decisive for the proper function of the chassis and the safety of the vehicle.

They may only be used for the purpose for which they were designed and manufactured.

Any use outside the intended purpose or any modification of the product can impair its function and endanger safety.

Improper modifications or use void the warranty and may result in the person using the product being held liable for damage to persons or property.

 

DANGER

 

Before replacing wheel bearings, make sure that the replacement part is suitable for the vehicle model in question.

This product plays a decisive role in vehicle safety and may only be fitted by qualified specialists in accordance with the vehicle manufacturer's current specifications.

Fitting requires special tools and sound expertise.

Improper fitting or incorrect handling can have serious consequences such as loss of control of the vehicle, accidents or considerable damage to property.

The manufacturer accepts no liability for damage or injury resulting from improperly fitted products.

 

MANDATORY

 

Only use the tools recommended by the vehicle manufacturer to avoid damage during fitting.

Fitting must take place in a clean environment to prevent dirt and contamination.

Only open the wheel bearing packaging immediately before fitting to protect the product from dirt and moisture.

Leave the anti-corrosion agent on the bearing – it is not a lubricant, but protects against corrosion during storage and fitting.

Do not clean the wheel bearing before fitting, as this can remove the protective layer and shorten the service life of the product.

Tighten all fasteners to the torque specified by the vehicle manufacturer.

After fitting, check the chassis and wheel alignment and have it readjusted if necessary.

Dispose of old parts in an environmentally friendly manner and in accordance with local regulations.

 

Use hand protectionUse eye protectionUse hearing protectionUse protective clothingUse foot protection
Make: BOOM Trikes, Wolf Trikes
Position: left, right

BOOM Trikes is a registered trademark of trike.company SG VertriebsgmbH.

Pursuant to Section 2 (14a) of the German Product Safety Act (ProdSG), trike.company SG VertriebsgmbH is deemed to be the manufacturer of the product offered.

Contact

trike.company SG VertriebsgmbH
Schneider 1
88410 Bad Wurzach

www.trike.company
office@trike.company

Please also observe the product-specific safety information!

0 of 0 reviews

Average rating of 0 out of 5 stars

Leave a review!

Share your experiences with other customers.


Skip product gallery

Fits with this part

BOOM rear brake disc, full LK 4x130
Rear brake disc BOOM solid PCD 4x130

Diameter 280 mm, thickness 10 mm, bolt pattern 4x130. For BOOM trikes with a VW Beetle axle. Also suitable for Easy-Trikes. Price per piece. Brake discs should always be replaced as a set for each axle!

€172.55*
Axle stub BOOM Classic
Centre pivot BOOM Classic

Stub axle for BOOM Classic models with VW semi-trailing arm rear axle.

€102.70*
Axle stub BOOM Muscle / Classic aluminium semi-trailing arm
Axle pivot BOOM Muscle / Classic aluminium semi-trailing arm

Stub axle for BOOM Muscle and Classic models with aluminium semi-trailing arm axle.

€199.92*